[1]周军文,黄东升*,沈玉蓉.重组竹横纹局部受压承载力试验研究[J].林业工程学报,2018,3(01):123-127.[doi:10.13360/j.issn.2096-1359.2018.01.020]
 ZHOU Junwen,HUANG Dongsheng*,SHEN Yurong.Experiments of partial compression bearing capacity perpendicular to grain of bamboo scrimber[J].Journal of Forestry Engineering,2018,3(01):123-127.[doi:10.13360/j.issn.2096-1359.2018.01.020]
点击复制

重组竹横纹局部受压承载力试验研究()
分享到:

《林业工程学报》[ISSN:1001-8081/CN:32-1160/S]

卷:
3
期数:
2018年01期
页码:
123-127
栏目:
森林工程与土建交通
出版日期:
2018-01-15

文章信息/Info

Title:
Experiments of partial compression bearing capacity perpendicular to grain of bamboo scrimber
文章编号:
2096-1359(2018)01-0123-05
作者:
周军文12黄东升1*沈玉蓉1
1.南京林业大学土木工程学院,南京 210037;
2.常州工学院土木建筑工程学院,江苏 常州 213032
Author(s):
ZHOU Junwen12 HUANG Dongsheng1* SHEN Yurong1
1.College of Civil Engineering, Nanjing Forestry University, Nanjing 210037, China;
2.School of Civil and Architecture Engineering, Changzhou Institute of Technology, Changzhou 213032, Jiangsu, China
关键词:
重组竹 横纹 局部受压 承载力 荷载-位移曲线 破坏模式
Keywords:
bamboo scrimber perpendicular to grain partial compression bearing capacity load-displacement curve failure mode
分类号:
TU366.1
DOI:
10.13360/j.issn.2096-1359.2018.01.020
文献标志码:
A
摘要:
为了解不同工况下重组竹横纹局部受压的力学性能,对5组不同工况下的重组竹试件进行了横纹局压试验,采用0.5 mm/min的速度加载至试件破坏,得到试件的破坏特征、极限承载力和每组试件的荷载-位移曲线。试验结果表明,重组竹横纹局压极限承载力比较稳定,其变异系数均小于0.1; 不同工况对试件的极限承载力和破坏形态有明显影响,承压区周围的围压面越多,其承载力越大。结合已有的木材横纹局压承载力计算方法和试验结果,考虑到重组竹本身硬度较大的特性,将重组竹顺纹和横纹方向的应力扩散长度均取为20 mm,得到了重组竹横纹局压的承载力计算公式,其计算结果均小于每组试件极限承载力的平均值,表明本研究得到的计算公式具有较高可行性。
Abstract:
To investigate the mechanical performance of partial compression perpendicular to grain of bamboo scrimber, and five groups of bamboo scrimber specimens with a total number of 40 were used for the compression tests, and each specimen group has same dimension in direct compression zone. The compression load was applied to the specimen with a velocity of 0.5 mm/min until failure, and the failure mode and ultimate bearing capacity under the different loads and load-displacement curves of each specimen were reported. The results showed that the ultimate bearing capacity of bamboo scrimber under partial compression perpendicular to grain was stable, the variable coefficients of each specimen group were all lower than 0.1, and the different loading condition had significant impact on the ultimate bearing capacity and mode. Moreover, the more the quantity of confining pressure face, the higher the bearing capacity can be obtained, and confining pressure also raised the compression stiffness under partial compression loading. Based on the existed calculation equation for bearing capacity of partial compression perpendicular to the grain of timber and the test results, and considered the high hardness of the bamboo scrimber, the stress dispersion length perpendicular to grain and parallel to grain were set to 20 mm, the calculation equation of partial compression perpendicular to grain of the bamboo scrimber was developed. Furthermore, and the calculated results according to advised calculation equation were all lower than the average values of the experimental ultimate bearing capacities of each specimen group, which verified that the calculation equation developed in this study was practicable.

参考文献/References:

[1] 叶良明, 姜志宏,叶建华,等. 重组竹板材的研究[J]. 浙江林学院学报, 1991, 8(2): 133-140.
YE L M, JIANG Z H, YE J H, et al. Study on board of reconsolidated bamboo[J]. Journal of Zhejiang Forestry College, 1991, 8(2): 133-140.
[2] 李琴,汪奎宏,华锡奇,等. 重组竹生产工艺的初步研究[J]. 人造板通讯,2001(7): 6-9.
[3] 张俊珍,任海清,钟永,等. 重组竹抗压与抗拉力学性能的分析[J]. 南京林业大学学报(自然科学版), 2012,36(4): 107-111.
ZHANG J Z, REN H Q, ZHONG Y, et al. Analysis of compressive and tensile mechanical properties of recombinant bamboo[J]. Journal of Nanjing Forestry University(Natural Sciences Edition), 2012, 36(4): 107-111.
[4] HUANG D S, BIAN Y L, ZHOU A P, et al. Experimental study on stress-strain relationships and failure mechanisms of parallel strand bamboo made from phyllostachys[J]. Construction and Building Materials, 2015, 77: 130-138.
[5] 张苏俊, 李晨,肖忠平,等. 重组竹工字梁抗弯特性研究及模拟分析[J]. 林业工程学报,2017,2(1): 125-129.
ZHANG S J, LI C, XIAO Z P, et al. Bending strength and loading simulation analysis of bamboo scrimber I-shaped beam[J]. Journal of Forestry Engineering, 2017, 2(1): 125-129.
[6] 周爱萍, 刘睿,沈玉蓉,等. 碳纤维增强重组竹受弯构件的极限承载力试验[J]. 林业工程学报, 2017, 2(3):137-142.
ZHOU A P, LIU R, SHEN Y R, et al. Experiment study on ultimate load-bearing capacity of carbon fiber reinforced polymer reinforced parallel bamboo beam[J]. Journal of Forestry Engineering, 2017, 2(3):137-142.
[7] ZHOU A P, HUANG D S, LI H T, et al. Hybrid approach to determine the mechanical parameters of fibers and matrixes of bamboo[J]. Construction and Building Materials, 2012, 35: 191-196.
[8] MADSEN B, HOOLEY R F, HALL C P. A design method for bearing stresses in wood[J]. Canadian Journal of Civil Engineering, 1982, 9(2): 338-349.
[9] van der PUT T A C M. Restoration of exact design for partial compression perpendicular to the grain[J]. Wood Material Science & Engineering, 2012, 7(4): 225-236.
[10] BASTA C T. Characterizing perpendicular-to-grain compression in wood construction applications[D]. Corvallis: Oregon State University, 2005.
[11] LEIJTEN A J M, SCHOENMAKERS J C M. Bearing strength perpendicular to the grain of locally loaded timber blocks[C]∥International Council for Research and Innovation in Building and Construction, August 28-31, 2007, Bled, Slovenia.
[12] van der PUT T A C M. Derivation of the bearing strength perpendicular to the grain of locally loaded timber blocks[J]. Holz als Roh-und Werkstoff, 2008, 66(6): 409-417.
[13] LEIJTEN A J M, LARSEN H J, van der PUT T A C M. Structural design for compression strength perpendicular to the grain of timber beams[J]. Construction and Building Materials, 2010, 24(3): 252-257.
[14] LEIJTEN A J M, JORISSEN A J M, de LEIJER B J C. The local bearing capacity perpendicular to grain of structural timber elements[J]. Construction and Building Materials, 2012, 27(1): 54-59.
[15] LEIJTEN A J M. The bearing strength capacity perpendicular to grain of norway spruce-evaluation of three structural timber design models[J]. Construction and Building Materials, 2016, 105: 528-535.

相似文献/References:

[1]黄圣游,吴智慧*,李琴.重组竹家具椭圆榫接合性能研究[J].林业工程学报,2011,25(02):40.
 HUANG Sheng you,WU Zhi hui,LI Qin.Study on joint property of ovaltenon of reconstituted bamboo furniture[J].Journal of Forestry Engineering,2011,25(01):40.
[2]朱一辛,饶文彬,关明杰,等.木竹重组材研究进展及开发前景[J].林业工程学报,2003,17(06):6.
[3]束必清 肖忠平 赵志高 等.重组竹框架结构的设计[J].林业工程学报,2014,28(05):82.
 SHU Biqing,XIAO Zhongping,ZHAO Zhigao,et al.Design on reconstituted bamboo frame structure[J].Journal of Forestry Engineering,2014,28(01):82.
[4]杜春贵,魏金光,金春德.重组竹阻燃处理工艺[J].林业工程学报,2016,1(01):51.[doi:10.13360/j.issn.2096-1359.2016.01.010]
 DU Chungui,WEI Jinguang,JIN Chunde.Fire retardant treatment process of bamboo scrimber[J].Journal of Forestry Engineering,2016,1(01):51.[doi:10.13360/j.issn.2096-1359.2016.01.010]
[5]张苏俊,李晨,肖忠平,等.重组竹工字梁抗弯特性研究及模拟分析[J].林业工程学报,2017,2(01):125.[doi:10.13360/j.issn.2096-1359.2017.01.022]
 ZHANG Sujun,LI Chen,XIAO Zhongping,et al.Bending strength and loading simulation analysis of bamboo scrimber I-shaped beam[J].Journal of Forestry Engineering,2017,2(01):125.[doi:10.13360/j.issn.2096-1359.2017.01.022]
[6]章卫钢,江文正,唐荣强.重组竹短期抗弯蠕变特性及其微观结构研究[J].林业工程学报,2017,2(03):33.[doi:10.13360/j.issn.2096-1359.2017.03.006]
 ZHANG Weigang,JIANG Wenzheng,TANG Rongqiang.Study on short-term bending creep behavior and microstructure of bamboo scrimber[J].Journal of Forestry Engineering,2017,2(01):33.[doi:10.13360/j.issn.2096-1359.2017.03.006]
[7]何文,宋剑刚△,汪涛,等.热油处理对重组竹性能的影响[J].林业工程学报,2017,2(05):15.[doi:10.13360/j.issn.2096-1359.2017.05.003]
 HE Wen,SONG Jiangang,WANG Tao,et al.Effect of heat oil treatment on bamboo scrimber properties[J].Journal of Forestry Engineering,2017,2(01):15.[doi:10.13360/j.issn.2096-1359.2017.05.003]

备注/Memo

备注/Memo:
收稿日期:2017-04-08 修回日期:2017-08-06
基金项目:国家自然科学基金(51378263,51578291); 建设部科技项目(2014-K2-014); 江苏省普通高校研究生(博士)科研创新计划项目(CXZZ13_0539); 常州工学院科研项目(YN1615)。
作者简介:周军文,男,研究方向为现代竹/木结构。通信作者:黄东升,男,教授。E-mail:dshuang@njfu.edu.cn
更新日期/Last Update: 2018-01-10